FREE SHIPPING ON ORDERS OVER $125.00 & FLAT RATE $12.99 SHIPPING UNDER*
This spigot screws on to all of our gallon additive jugs and makes filling your smaller bottles a breeze.
Some say its easier than using a pump.
It's made from sturdy plastic to provide long lasting use.
We have left the jug on its side for days without any leakage, but would still suggest standing the bottle up when not in use to prevent any issues.
The spigot works decently, but due to being lower than the fluid level, some fluid is dispensed, but then air is drawn in to break the vacuum created. The theory is good, but a modification is needed to allow venting for smoother fluid dispensing. The plus side of alternating between dispensing & venting, is that refilling bottles is cleaner (no overfill, if careful). Opti-Lube Response: Thanks for the review Raymond. We have found that if you put a pushpin or thumbtack in the bottle just below the slanted handle, you can pull it out when your filling and put it back in when you set the bottle upright and storing it. That gives you the vent needed and also prevents spilling/smell when not being used. Hope that helps.
easy to use
SKU: OPT-GM1-NA
SKU: OPT-GE1-NA
SKU: OPT-PQRT
SKU: OPT-XPD1-NA
SKU: OPT-XL1-NA
*FREE & FLAT RATE SHIPPING APPLIES TO RETAIL ORDERS WITHIN THE CONTIGUOUS US.
